OKX Wallet extension

List of contents of this article:

• 1, How to ignite manual transmission
• 2、How to start the engine of a manual transmission car
• 3,OKX Wallet extension What is the correct way to start the manual transmission with one click?

How to start the manual transmission

1. There are two main ways to start the manual transmission car: step on the clutch pedal first-hang the idle gear-ignition-step on the accelerator ignition (make sure in the idle gear ) - Step on the clutch - hang the first gear - let go of the brake - slowly lift the clutch - step on the accelerator. It is better to step on the clutch first and then ignit, because this can prevent accidental start.

2. The correct way to start the manual transmission is to put the gear in neutral gear, step on the brake and clutch pedal at the same time, insert the car key into the start control switch, and turn two gears to the right at the same time. After starting, hang the gearshift lever into the first gear, release the handbrake, slowly lift the clutch pedal, and start with a small amount of refueling.

3. The following are the steps for starting a manual transmission car: Make sure that the gear is in the "id" position. Before the vehicle starts, the gear lever must be placed in the "id" position. If it is hung in another gear, the vehicle may suddenly move forward or backward, causing safety problems.

4. The ignition steps of the manual transmission car: make sure that the gear is in the air gear before starting, and pull the handbrake.

5. First of all, on the manual transmission car, hitThe operation of the fire is to set the gear to the idle gear, then step on the clutch, then set the engine speed to the maximum, and finally set the ignition switch to the "ON" position, and then the ignition can be turned on.

How to start the engine of a manual transmission car

Make sure that the gear is hanging in the idle gear before starting, and Pull the handbrake.The function of this step is to fix the car on the ground to avoid slipping when starting. Step on the brake and clutch pedal at the same time. For safety reasons, the engine is only allowed to start when the driver steps on the brake pedal.

Confirm the gear and handbrake. Make sure that the gear is idle and the handbrake is in a pull-up state. Hang gear. Step on the clutch pedal and brake pedal, start the engine, put the gear in 1st gear, and then release the handbrake. Lift the clutch.

The specific method is to start the manual transmission engine. First, check and tighten the parking brake lever (to ensure safe start). In order to facilitate the smooth operation of the engine, press the clutch pedal to the bottom. Put the transmission joystick in the idle position.

What is the correct way to start the manual transmission with one click?

1. How to use the manual transmission one-click start: open the door to enter the car and adjust the seat belt of the seat; check whether the gear is in the air gear, and if it is not in the air gear, adjust the gear back to the air gear first; step on the clutch to the end and press the one-click start button.

2. Step on the clutch, brake, hang idle gear, pull the handbrake; press the one-button start button to turn off the engine. How to use one-click start of a manual car 2 What is the correct way to start a manual car with one click? First, open the door to enter the car and adjust the seat belt.

3. Hang the idle gear. Step on the clutch to the end (why step to the end to start? Because this is a protective measure to prevent some sloppy people from starting the car in gear, so that the car will splash out! So step on the clutch to the end, so that even if you start in gear, the car will not move.